Barn door kits – Granaries are places to store food and equipment on their land, and for many people the barn becomes the centerpiece of the daily work on the farm. Granaries normally closed to the outside to protect against the elements. If for some reason the barn door is damaged or does not have a door barn, animals can escape and wind and rain can damage equipment. You can end this quickly and economically by building a barn door kits. Measure the opening barn door with a tape measure. Measure the height and width of the opening where the barn door will be installed. Cutting boards for the frame barn door by two tables laid aside the width of the opening. Also, cut two tables laid aside plus 6 shorter than the height of the opening inches.
Measure the square frame diagonally from corner to corner and cut two tables laid aside the same length. Place the two tables in the Plaza running diagonally from corner to corner. At this point, you must have the square shape of the frame with an X inside. Screw two wood screws 2 inches across both the top and sides of the ends of boards dipped in each of the four corners with a stun gun to secure the structure of the bottom. Cut a piece of plywood 3/4 inch for the same dimensions as the height and width of the door frame. Place this piece to the structure by placing on top of the door frame on the floor. Be sure to align the edges of the wooden frame edges.
12 Photos Gallery of: How to Make Barn Door Kits
A 2-inch screw through the plywood and in frame with an electric screw gun in each of the four corners wood. In addition, placing a screw in the center point of each of the four sides of the frame. Paint or stain the door to match the colors of the barn door kits. Allow the door to dry for 48 hours and then apply a clear coat of sealer wood all the time to painting. Allow the sealer to dry for 48 hours, so. Attach the strap hinges to the door once the paint and sealer have had time to dry. Attach one side of the hinge at the top outside corner of the frame 3 inches from the top edge of the frame using two wood screws 2 inches and a stun gun. Install another hinge exactly as 3 inches from the lower edge of the same side of the frame.